There is also a palm rest that can be attached to the top of the Stick’s palm rest if you feel you need more support for your wrist. To remove one, simply use the Allen key to unscrew and swap to one of the other three HAT positions. With the supplied Allen key, you can change the HAT switch layout to your specifications. Once installed, you will have a little Saitek icon in your taskbar, next to the clock. We recommend that you install the latest driver and SmartTechnology (ST) programming software from our website. This is similar for USB ports from the PC case. Take note that a non-powered HUB might be able to power this device but if additional devices are added, the power requirements will probably exceed what is provided by the HUB. The USB cable labelled PC plugs into the back of the PC or a powered USB HUB.The PS/2 cable labelled Sw/P plugs into the back of the Panel.The PS/2 cable labelled Stick plugs into the back of the X65F Stick (check that your pins are all ok there should be six in the head of the plug).These connect to the stick, panel and the PC. If you take a look at the back of the throttle, you will see three leads. Once you attach the FIP, you can then attach the USB cable, which will need to be plugged into the back of the PC or preferably, a USB-powered HUB. ![]() If you prefer, and have a Pro Flight Information Panel (FIP), this can take place of the info panel. It does not matter which side the panels go on. Place these on the brackets and use the screws in the four corners.
0 Comments
Leave a Reply. |